🔌 DIGITEN Sensor Control Solenoid Display Review

Tried to calibrate the controller using k-value adjustment. At k=7.49 the regulator outputs 9.3 liters instead of the default 10 (or -7%), at k=7.50 it outputs 10.9 liters instead of the default 10 (or +9%). I assume the correct value for k should be 7.494, but the controller doesn't allow for such fine tuning.

Reads flow and volume (metric) well and turns on and off via the control panel. You will need a lot of teflon tape. As a rule of thumb, plastic threads should not be taped. But for that you need duct tape and some of those. The connections can't really be 1/2 inch as they leak. However, if a lot of pressure is required now, it will still leak.

I've wanted a water flow meter with magnet for brewing for a long time but couldn't find anything in my price range with good reviews and gallons before this unit became available (I've been looking for one for several years) . It was easy enough to assemble and set up. I had to use multiple NPT 1/2" threaded connectors since all connectors are male (I would have been more comfortable if the magnet had female NPT threads on both sides). Calibration took about half an hour. Constant k for my…