🚦 Enhance Your Wrangler's Safety: EAG Black Textured Off Road Taillight Tail Light Euro Guards Steel Protector for 87-06 Wrangler TJ YJ Review

I gave two stars because the quality (material, weight, finish) is excellent, but I was unable to fit the taillight assembly into the shield. I've seen similar comments on here, so maybe I'm not as mediocre as I thought. I thought I must be missing something and went to the instructions. They can also be thrown away. My installation approach was simpler and more obvious. The instructions were complicated as disconnecting the cable meant you had to crawl under the jeep. The slot on the back of…

Installs the kit on my white '94 YJ. Ease of installation. Please note that the factory screws that attach the flashlight to the body are too short when you add the EAG protection. You need to buy 6 bolts or screws (3 on each side). I found some stainless steel screws at Home Depot, just search for them: 12-24 x 1 1/4”. Inch screws also work. The headlights need to be separated from the body to install the protection, the left side was bright, the wiring harness is long enough to be…

They seem pretty strong (more on that in a moment). Bought it because I've always liked the look. They came quickly, well packaged and the workmanship was great. Abstracts are not cheap. The next part is dedicated to the jeep. Installation is very easy, just a few screws to remove the taillight. Disconnect/connect the wiring harness and reassemble everything. But the passenger side is hard. The guards are a simple setup, but getting to the Jeep's wiring harness wasn't easy. There isn't much…

Great quality and they fit my Wrangler perfectly. They are very easy to install and I will walk you through the steps for my 2002 model year. 1- There is a rubber cover under the jeep, behind the steering wheel and just below the taillight. Pull on it and you will see the wiring harness that connects to the taillight. Disable it. There's a tab that you press to release and then it slides out. 3- From the outside of the vehicle, unscrew the four screws that secure the taillight cover (Phillips…

Looks good and fits my 04 Wrangler TJ Rubicon well. The matte black textured metal looks great and feels very strong, a much better and more durable finish than competing products from Smittybilt or Rough Ridge. My spare is a 33" tire with a heavy duty spare tire holder and I can still open the tailgate fully, I only had to shave about 1/4" of the plastic on the holder, no big deal but anything bigger than a 33 you can on encounter problems. Because the bottom is open, it gives the illusion…

Many of them like it. I still give 5 stars, although the installation is a bit of a hassle. You need to access each lighting connector located on the bottom of each wheel well (side clip connector). First, simply pull out the protective tab (located at the bottom center of the fender) and bend it back - equally on both sides. Also, you cannot see the plug at first, do not pull on the cables. Just run your fingers over the corrugated tube and you will feel that the plug is hidden behind the box.