🔴 EBC Brakes DP31574C Redstuff Ceramic Low Dust Brake Pads - Reduced Dust, Superior Performance Review

I've had these on my Mazdaspeed 3 for almost 10,000 miles, easy install, good stopping power, slightly less initial bite but overall good braking

Very little dust for my Mazdaspeed 3. They are mated to perforated slotted rotors and now my car stops on a dime. Much better than the Hawk HP+ pads I replaced.

Great brakes! I have them on my Mazdaspeed 3 and love them. I installed the front brake and rotor and can say that the brakes are well received. Bite-resistant and much, much less dust than my previous pads (original).

Make sure you follow the EBC fitting procedure to get them working well: [.]Overview: They come with a special abrasive, to facilitate marriage rotors and pads together. You want the pads to have full contact with the surface of the rotor, so you want this abrasive compound to wear down slowly until the entire pad is in contact before doing the final hard break-in procedures. Take your time doing this, just use the weight of your foot on the brake pedal for a while, let the compound do its…

I have them on my 2nd generation Mazdaspeed3, the car has been modified to around 300hp. I thought these pads would be a decent upgrade for a moderately modified car, but not so much. They don't bite at all and fade quickly. They also seem to leave some heat spots on my new high carbon Centric rotors. The standard pads were much better. These pads don't make a lot of dust because they're ceramic, but they don't hold up very well either. I sell them after only 1000 miles and buy yellow stuff…