Header banner
Revain logoHome Page
edelmann 71206 power steering return logo

Edelmann 71206 Power Steering Return Review

2

·

Average

Revainrating 3 out of 5  
Rating 
3.0
🚗 Steering System, 🏎️ Performance Car Parts & Accessories

View on AmazonView on ЯM

Media

(1)
img 1 attached to Edelmann 71206 Power Steering Return

Details

BrandPlews & Edelmann
MaterialSynthetic,Polyethylene,Rubber
Item Dimensions LxWxH12 x 9 x 1.5 inches
Item Weight0.6 Pounds

Description of Edelmann 71206 Power Steering Return

Original equipment equivalent assemblies. Manufactured using nitrile tube and oil-resistant synthetic rubber cover. Manufactured with a special chlorinated polyethylene (CPE) tube with a temperature capacity of up to 300 degrees Fahrenheit. Mounting brackets, heat shields and convoluted sheathing to protect the hose are included where applicable. Bulk - 3/8 inch i.d. return hose (j189).

Reviews

Global ratings 2
  • 5
    0
  • 4
    0
  • 3
    2
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

Waste of Money for my opinion

Through trial and error, I found that this power steering return line was a complete failure. It didn't fit properly and leaked like crazy, causing more problems than it solved. .

Pros
  • None.
Cons
  • Poor quality, incorrect fit.

Revainrating 3 out of 5

Great for large radius bends but not tight bends

This is a great thick hose but it's too stiff and will kink if you try to make a lot of bends in OEM size to fit.Of course these OEM elbows were factory formed, in my experience they weren't too tight for most hose brands.I had to make two 90's and two 180's.Both 180's buckled and the 90's buckled a bit but it was ok. These were the tightest of 2" radius bends, not too many to ask of a 3/8" ID hose. These aftermarket hose reels/springs that allowed the heater hose to twist in small radius bends

Pros
  • Inlet - 3/8" ID Return Hose (j189)
Cons
  • Doubtful