🖨️ ESUN 1 75mm 3D Printer Filament 2.2lbs - Additive Manufacturing Products for 3D Printing Supplies Review

This spool was disappointing and I was hoping for a better result. Adhesion to a glass pad was not possible unless I used butt welding. It ruptured so badly that it left holes in the prints and ruined several of the prints. And it releases so badly through the extruder that I had to clean it before every print attempt. Maybe I have a bad spool of plasticine, it's possible. I will at least say that pla plus is much better in terms of pressure and adhesion.

Prints great, but here's the thing... I wanted clear, and this filament does NOT print clear, it's just translucent. The light sort of goes through, but even with a bright orange repeater in a printed magazine, the bright orange cannot easily be seen through the "transparent" flat-walled magnet body. If you're printing something with LEDs inside and want a soft glow, this works fine... but if you want to see a glimpse of detail inside (e.g. how short your store is empty) you're SOL.

I buy eSun/Intservo filament all the time, I really like the quality. I bought this clear roll for a project for the first time. I'm trying to print some 200mm high objects. Every few hours this thread completely clogs my system where it has never gotten stuck. According to research, the filament tolerance is much higher than eSun's conventional materials. Dimensional accuracy should be +/- 0.05mm, I see +/- 0.15mm to 0.2mm. As soon as I cut a section everything goes fine again until the next…