ESUPPORT Heavy Duty Car Silver Contact Rocker Toggle Switch, 20A 125V SPDT 3P, ON/OFF/ON, Metal Copper Terminal, Waterproof Boot Cap, 12mm, Pack of 3 Review

I received a pack of 3 switches but no rubber boots. I need to use one of these switches outdoors so I'll either have to return them or buy a separate case and hope it fits.

Turn off my RV's battery box for our backup camera. No more opening and fumbling with ring connectors, waterproof, has a good positive click in every direction. The terminals are easy to use and well thought out.

Really solidly built. The terminals are attached to the switch much more securely than some I have purchased. I will definitely buy them again. I had to buy a pack of five as it's only $2 more for five switches and I need more.

I was a bit skeptical about the quality when I ordered these switches. I have purchased several schematic switches over the years. They are very well built and have good left and right throw power. After installation, I don't even worry a bit about water getting inside. The switch is durable and I will buy them again.

I fitted 2 of these switches (to control a 1.5v AA battery) and they both failed, one after 2 months the other after 5 days. I have one switch left, but I'll get rid of it and order another brand. It is cheaper to pay more for a quality switch the first time than to buy it after purchase.

This is a well built heavy duty 12v switch. I use this switch in my car to power my ham radios. The switch is used to switch on from a 12V on-board network or to switch to an external Alinco DM-330DMT 12V switching power supply for stationary amateur radio applications. When the amateur radio equipment is not in use, the switch is off for safety reasons.

I bought these to plug into the middle of a 5V USB cable so I can quickly turn off the power without unplugging it. It worked great for that! However, I would like to warn anyone who uses them that the screws are not small enough for such thin wire. I ended up soldering them to the inside of the screws. I also had to disassemble one and can personally confirm that everything inside is also of high quality. Strong, thick metal parts and good build quality. Definitely worth the money and I…

These switches are nice looking and big. The switch plates are nice, but they're so flimsy it's quite difficult to tighten the nuts without ruining them. The soft aluminum is just too delicate to hold against the switch, and the little burr that goes into the slot to hold it just disappears. It takes a very careful hand to keep the panels and panels pressed firmly and aligned the way you want them. Also, I had to remove one of the switches and it was very difficult for me to remove it because…