🔧 Black Nylon Stainless Steel Braided Fuel Injection Line Fitting Kit - EVIL ENERGY 8AN PTFE E85 Hose, 16FT Length, 0.394inch Hose ID Review

Complete overhaul of the E-85's fuel system. The price is fantastic and the hoses and fittings are every bit as good as the expensive (overpriced) big brands.

Your braided rubber cords are fine. The outer braid is very loose making fitting the fittings very difficult, but with patience it is possible. Your teflon hose is of very poor quality. Same issues as standard rubber hose but added inferior plastic. At any bend greater than 45 degrees, it will begin to collapse on its own. Straight runs should be fine. I saved this last minute backup as needed, but for my main build I went with a much higher quality product from FinishlineFactory.

Used this kit to replace rusted fuel lines on my 2002 Silverado. This kit can easily be cut to length and the connectors fit directly with glued ends. The fittings match the supplied parts exactly and there were no leaks. 16 feet was enough to re-route the fuel return and vapor return lines on the truck using the factory guide. An additional 10 foot section is needed to make all three lines including the filtered umbilical. The number and type of connectors exceeded my requirements although I…

I needed to re-route a fuel line on my 1975 Plymouth Duster. The existing line was a steel line from a mechanical fuel pump at the front of the engine and ran up the engine, through the valve cover and into the carburetor. The fuel line was getting too hot and this seemed like an easier way to install a new line. I was very happy with this purchase. It looks good and is very easy to use. All hardware is made from high quality aluminum and looks fantastic. Be sure to wrap tape around the steel…

High quality PTFE hose with dense stainless steel braiding, ideal for high temperature and high pressure applications. I used it to make a connection between a shop air compressor pump, air dryer, particulate and water filters, and a compressor storage tank. Compressor pump discharge head temperatures approach 300F when working hard on hot days, and this hose easily handles both heat and pressure (150psi). The hardware also works well, although I'd rather choose a different color (preferably…

I used these lines and fittings on my race car. After I've run all the new lines and done all the work, as soon as I turn on the fuel pump I notice a 90* leak at the turntable. First I didn't want to give a bad review because it was spot on. I've tried contacting the manufacturer to see if I can get a replacement. But two weeks later I received no reply. I find the PTFE tube in the middle to be fine, even if its inner diameter is slightly smaller than actual AN specs. But the steel mesh and the

At first I was quite intimidated by the fact that I only used Earls, Russel etc fittings and braided nylon/rubber hose. Line installation also added with a braided look. With -6AN, the outer diameter of the line is much smaller, neater and cleaner, but the inner diameter is the same! Get some looks and show it's awesome! The fittings aren't as heavy as Earls, Russell etc. But for the price and the speed with which I received it it was 5 stars and 5 stars across the board! If only they had a…

Installed the 45 degree swivel fittings on the gearbox and tightened them up really hard because I'm not sure if they blow oil all over the place or not because it can wiggle quite well . I don't understand why they can do that when they are on my heels. If that's why I mess up a $4,800 drivetrain for my race car, that stuff sucks. Fittings and Russell line have to be purchased instead so I know what to worry about. Update: Just like I originally thought these 45° swivel fittings were leaking…