🔧 High-performance FitBest Carburetor with Air Filter for Honda GX160/GX200 Engines | 5.5HP/6.5HP | Replaces 16100-ZH8-W61 Review

My honda gx160 engine would not start due to a clogged carburetor, it is easier to change the carburetor than to clean it. I put this one on and it caught fire the second time and didn't need to be adjusted. hope it lasts

This new carburetor took less than 5 minutes to install and no adjustment was required. The pressure washer started with the first pull on the cable and ran great when idling. Many more parts and time would have been required to restore an old carburetor.

The quality is fully in line with OEM, everything fits perfectly, even the gaskets were of good quality. I have used Fitbest on my other Honda trimmers and have had great success. It was the same with this carbohydrate. Installed easily, pulled up in a few simple steps, works great. For the price, it's not worth repairing an old carburetor.

Probably the best deal I've ever had on Amazon. Not only did it start on the first pull, my washing machine is twice as powerful as it used to be. I broke the fuel line while removing it. Look in the box, there's a new one. Destroyed my gaskets by removing the old carburetor. Look in the box, all three are new. Defective air filter. Look in the box. New included. Brilliant.

Spent two days cleaning the stock carburettor but couldn't get it to work properly. The original needed fluid to run, and then it would die. Even after we started it, it would only run at full throttle, meaning we couldn't get enough RPM to get the pressure washer running like it was supposed to. starts immediately after the second or third jerk without starting liquid. The thing is twenty years old, hasn't run seven years without a service in its entire life, and now it works exactly as I…

The carburetor kit came with no papers or instructions. I was a bit skeptical at first when reading reviews of the intake manifold angle. I tried twisting the tube, as other reviewers have successfully done, but was afraid it would bend or break. After re-evaluating, I found that the plastic baseplate has a fuel line support/guide that redirects the fuel line to accommodate the angle of the fuel pickup tube. The housing to which the recoil is attached must be removed in order to replace the…

I have two pressure washers in two different locations, one with a 5.5hp Honda GX 160 engine and the other with a Honda GX 200 -6.5 hp engine The GX 200 is in storage and a valve on the gas line accidentally opened during transport. The device stood for 18 months and the carburetor was painted, even with stabilized gas. This carb arrived today and I installed it in 20 minutes, it started on the first pull and ran high and low speed for 2 hours with no problems. I had to change the air filter in

I bought a Karcher pressure washer with a Honda GX200 engine because of theft. It didn't have many hours, but it sat for years with a full tank and left hand throttle, so the carburettor was very smeared/varnished. I was able to get it running fairly well with no choke under load, but had to close the choke at about 75% to keep it from stalling under load. Given how cheap new carbs are these days, it makes more sense to just replace them. compared to cleaning the old. I installed this new…

My pressure washer sat for over a year without starting and despite using a fuel stabilizer showed all the classic symptoms of a clogged carburetor. Spark? Yes. Run with starting liquid? Yes, just for a few seconds. Fuel line clogged? nope I thought about rebuilding the carburetor for a few minutes before I found I could buy this replacement for what I find very cheap and the reviews were good so I gave it a try. I installed it in about 30 minutes and it started up and ran great. Thanks to…