🔌 Genuine Ford EL3Z-14293-A Black Terminal Kit: Enhance Your Vehicle's Electrical System! Review

As others have said, "It should have been a recall." I had an issue where my 2013 F-150 happened to be would not start as if it had no gas. Luckily I found a forum that mentioned an issue with a blown fuel pump fuse. When I pulled mine out it was a little melted and the metal was slightly obscured by sparks. I replaced it with a new fuse. But to really fix it, you just have to get this kit or you'll end up with the same problem over and over again. This is really easy to fix and there are some…

Ford Factory Part. Replacement kit for a 20 amp fuel pump fine-wire fuse that is overheating/melting. Took me about 20 minutes to fix it. I waited the longest for my soldering iron to heat up. Be careful if you have F150 fuse problem. Comes with instructions and all necessary parts. 20A fuse, 2 sizes or pre-cut heat shrink tubing, label on fuse box and new wire with clip for fuse relocation. If you watch the YouTube video of the guys doing it, you'll see that it's very easy. Save some money and

I bought this kit some time ago for my 2014 F150 FX4 5.0 which has not had any problems with the fuel pump before nor when I went into the junction box to upgrade. I've read about enough people being stranded, the price is a lot less than a tow truck ride home and that's an obvious Ford design, they didn't have any regard for the customer for years as this failure mode runs well into their lineup. . I also cheated and watched one of the many videos on YouTube before going to the shop. It took a