🔪 Freud 99-402 Crown Molding Shank Review

Often used. Ran over 400 linear feet. As long as it doesn't need to be sharpened. It's a bit better than paying for crown moldings at local lumber shops. Big money saver. Worth the price. Excellent quality. Freud has always impressed me with his products. If you leave an extra bead on the tree, the piece will end up being about 2.5 inches tall, which works out to about 1.375 on the piece when installed. A bit small, but I can do it in one pass with no problems. Beautiful photo frames made with…

Excellent milling cutter as you have come to expect from Freud. Delivered on time and in excellent condition. YOU MUST use fingerboards or some other method to hold the router railing in place. Leave the router about 1/8 inch above the tabletop, also making sure the material is wide enough to leave an edge at the top. If you don't leave the top and bottom edges, you won't be able to control the material. Do a few passes and you'll get great results. I used 4 Kregg fretboards. I cut a 2x4 washer

Who needs a router when you've got a big router and such! This Freud cutter is a beast. big and heavy and very well made. Due to its size and design, however, it is only intended for use in a router table. I've done a few yards of crown molding with this nozzle and it saves a lot on price after about 5 feet! Buying strips off the shelf at a hardware store is VERY expensive. Although the cost of this router bit is on the higher end of the router bit scale as mentioned, it will easily save you…