🔧 Enhance Precision and Flexibility with Freud Premier Adjustable Stile 99 760 Review

Some people say they have bits with chips in the carbide part of the cutters. Freud uses the best quality carbide. The higher the quality, the more fragile the cutters are. Don't let the knives bang against each other. For example, a higher quality carbide like C4 is significantly more prone to cracking when the carbide collides with other carbides. In the past I have received poorly packaged beats that were cracked. Freud quickly replaced the damaged item.

I bought this set to make flat doors with this profile. Of course, no two flat panel displays have a predictable thickness. But there are no problems with these bits. They are highly adjustable in thickness, allowing the rail and stand grooves to be the same width as the panel thickness and the rail end ribs perfectly matched to these grooves. Of course, this requires a few test cuts, but for a layman like me this is part of the fun. These Freud bits cut great and are adjustable. My rails had…

Cuts very well. I'm a big fan of Freud blades and bits, but I'm giving them 3 stars for two reasons. On the one hand, the width of the groove and spigot and the axial height do not match at the factory. None of them were even standard. The slot measured 0.242 inches and the spigot was 0.210 inches. The axial height between slot and tenon was not 0.017 inch and had to be adjusted. It took some time to set them up, cut samples and retune them. Freud offers different spacers in different strengths