💡 Aluminum Heatsink for Raspberry Pi - Enhanced Thermal Transfer Review

These are exactly as advertised so if you need small heatsinks and thermal adhesive they are perfect. I use them to set up some easydriver stepper motor drivers. However, I could see that they work fine on Raspberry Pi or VGA Ram as stated in the description. Pay attention to the dimensions, for some reason I thought they were 10mm when I ordered them (I haven't actually checked) but was pleasantly surprised to find 14mm. Perfectly fine for my use case, but in case, like me, you've just seen…

I ordered these for a small all metal HDMI capture device that gets very hot when in use. I stream on Youtube and Twitch, as does my roommate. His recorder of the same model burned out from overheating so I had to do something. They work to passively cool the device. They were originally intended for the Raspberry Pi, but they work perfectly. I lined them all up on one side of the device, the side that gets the most heat, and I found that the recording device was a bit more stable. I am…

I would give this 5 stars if the thermal tape was already attached. The squares aren't all cut evenly though, and because the heatsinks are so small, it's difficult to align them without overlapping, and then you can also get blisters that you hope will flatten out and not have air pockets . when you put them in place. I took some 20mm radiators from other brands and they came pre-fitted. You can see the difference by looking at this: these have the bits dangling to one side because it's almost