Enhanced Safety with UTVDistribution Seat Belt Harness OverRide Clip Bypass Plug for Yamaha YXZ Viking, Kawasaki KRX Mule Teryx Models Review

Perfect for 2021 Yamaha Wolverine X2. Looking at the connector I thought it was too small but it fits perfectly and works.

We use our UTV as an agricultural implement, never see the road or high speeds. Other than that, this mod works great for us. This eliminates the need to fasten a seat belt in our UTV to get to 5 mph.

This is a must if you are adding seat belts and want to get rid of seat belts in Yamaha YXZ side by side. You only need one per car. This closes the seat belt loop, allowing you to drive without a seat belt.

Very easy to install and works great. After removing the rubber boot around the seat belt latch, I raised the bed and was able to unclip the wires from the clip holding them in place. Lifted the cables until the connector was exposed, disconnected the factory cable and installed a bypass connector. Reinstalled the rubber boot and routed the wires back to the terminal.

Clip completes the seat belt alarm circuit and silences the Yamaha Viking 9 mph alarm. You'll have to lift the seats and remove some panels to reveal the connectors, but the clip connects easily. Driving at 10/15 mph on my flat two lanes and getting in and out of the Viking to clear branches didn't require a seat belt. But always use on hills and roads!

This turned off the seat belt light exactly how I wanted it so I think it worked exactly as advertised. It wasn't obvious where to install it and no instructions were provided. I asked a question on Amazon and a few people were kind enough to help me. Essentially you unplug the cable coming out of the base of the driver's seat belt and plug it in. On my Viking VI I only had to loosen the plastic cover to install it. Easy enough once you know what to do.