🔴 HATCHBOX 3D PLA 1KG3 Red Filament: Enhanced Dimensional Accuracy for High-Quality Prints Review

The first two prints were out of tolerance, but three more had problems with broken filament, in the extruder, spool tearing or even in the feed tube (for multiple parts). Not sure if it was a bad throw or something like that, never happened. I was able to print another print without breaking so I'll have to keep an eye on it.

The print quality with this filament was excellent. I have no issues with sticking to the bed or uneven extrusion. The main problem with this thread is that it is fragile. Keeps stopping when printing. If I leave filament in my printer overnight (not in active use), it always comes out of the extruder in the morning. Like it's wound too tightly on the spool and won't unwind. Very disappointed with Hatchbox and this product. I don't recommend it - there are better products out there for 3mm…

Prints are good, the filament tends to break between the extruder and spool, especially if the printer is not used for about a week between prints. It usually cracks once or twice when I reload the extruder, but after that it's fine for a few more prints. I did not notice any fragility on the parts themselves, only on the filament before printing. It's 3 to 4 stars because the prints actually come out pretty well and tears aren't usually a problem when I'm printing multiple parts in one…