Enhanced Hi-Lift Jack HK-B Black Handle-Keeper: Ultimate Security and Convenience Review

This took 4 months. I have a jack on the hood of my jeep. The grip protection is in two parts. I'm not sure how it happened. The caretaker was not charged, the jeep stays in my garage when not driving (which is quite common since I have a company car that I drive every day). I thought this part would take longer than her.

As many others have pointed out, these things break VERY easily. After my mind broke, I attempted to bend one of the whole halves. It's about an inch thick to rubber, which should be indestructible. I stressed it lightly just enough to form a crack and then it spread as if the material was brittle. I'd rather make my own than buy a new one.

jacked this up on my wife's jeep. It lasted less than 24 hours before splitting in half under road traffic conditions. Unfortunately I waited out the 30 day return window before installing it so I just don't have the cash. The one I bought was black and there seem to be a few other reviews that split the black in half. I need to look for another solution or maybe try red.

I have a little over a year it rattled a lot and when I took it off to rent a jeep for the summer I noticed it was in half was broken. It must have been like this for a while as I've had the rattle for a while. It doesn't carry any load or weight so I'm not sure why it broke in half? The product isn't durable enough and I don't want to get a replacement as they aren't cheap. I'm just going to throw that away and tie the jack handle to the bar.

Not much to say here. A simple piece made by the same people as the jack. They hope and expect that he will come and do what he has promised. And it is. I see a lot of negative reviews on this Revain which makes me think that in this case, as is so often the case, we should buy direct from Hi Lift. I literally put mine on today. I can buy another one if needed but if I need to buy another one I go to Hi Lift as I have a little doubt that they will continue to make inferior stuff again and…

I love my Hi-Lift Jack. Bought my pen holder in May 2015. You are not authorized to sell this pen holder unless it is designed to last more than a few months. My lift is attached to my hood and was purchased to keep the handle snug and secure. First, the internal tabs on the "cross" portion of the holder that wrap around the lifter (rather than the handlebar) broke, causing the handle to sag. Eventually, under the weight of the slack, the entire guardian grip split to one side, preventing it…

Purchased to keep handle firmly/safely in place when not in use. Going to install it today (when I actually had time to sort it out and it was late going back) it was tight trying to get the screw over the top. As soon as he cleared the latch on both the jack and the handle, he slid down the wet slide like a child. It was a waste of money and I am disappointed in the product. I don't have the $15 now that all the other things in my life cost me. Of course it's $15 but now I need to find another

Perfect fit. Prevents the handle from moving. What else can I say Update: 05/21/2015 My hanger bracket just fell apart?! My jack is mounted on a roll bar in my JK. I haven't removed the hard top since I bought the jack and crank in February so it hasn't been in the sun or weather. Today I opened the back door and the goalkeeper's grip is half on the ground. Has anyone else had this? What the hell? There is no tension other than holding the handle. If I could I would put zero stars! Update…