🔌 Plug-In Simple Vehicle Wiring Kit by Hopkins 42625: Streamline Your Vehicle's Electrical Connections! Review

Easy to install with everything you need to connect a taillight and lighted trailer. Works as advertised! Highly recommended.

Installation was very easy - just follow the instructions. I used plastic zip ties to attach the wire to the back of my aftermarket bumper. easy peasy works so well.

This was very easy to install on a 2006 LJ. Connected to the standard cable and works fine. Plenty of cords to put the plug where you need it. Some kits come with a trailer fork mount. I used a zip tie to secure it to the bumper, but some may want a fancier mount.

Discreet pendant. What I didn't like was that there was no bumper. It's just a seat belt and you need to find a way to fasten it. There are no instructions, but here's the important part: use the connector on the back of the jeep on the driver's side. If you use the passenger side, you only get the right taillights. On the driver's side, the controls are on both the right and left.

As they say, it easily connects to the existing wiring harness. I just need to ground the wire harness to the chassis, which is what I did with the license plate screw. Good quality watertight connectors and enough cable to route the trailer plug to the right place. Literally the easiest way to hook up a trailer to your tj. I've had it for over a month, it's been in salt water many times and shows no signs of wear. If you need trailer lights on your Wrangler, you're going to be a sucker for not