🚿 Hourleey 0.75 Inch IPS Isolator Tankless Water Heater Service Valve Kit, with Pressure Relief Valve, Premium Brass for Optimal Performance Review

Was a little concerned after reading some negative reviews but decided to give it a try as most of them are positive and Revain is easy to deal with should I go back got to. Some reviewers have complained about the leak. I had one of the threads that leaked a little under pressure, but tightening it fixed the problem. Just make sure to use tape if needed, tighten well and you should be fine. It also doesn't have to be overtightened. Functionally, all of the valves felt good, nothing in the kit…

Ordered and then found I needed to add a safety valve which would require an extra tee and fitting - but when the valves arrived it was all part of this valve kit ( not illustrated). the photos) is a nice surprise that will save you a lot of money on extra brass fittings. Mounts directly to a tankless HWH and then to a house installation with 18" stainless steel flex lines for PEX - Top collet rotates for easy valve alignment and an easy, strong seal - Valve bodies are cast/forged from a single

I used to do plumbing projects and replace water heaters. I got it all together and put teflon tape on all the brass threads, pushed everything in, and it's dripping out of these valves where they come together. I thought maybe I just needed to tighten it up - no luck. I took it all apart, wrapped it 10 times with teflon tape and reassembled it correctly (practicing tightening it). Still flowing, only slowly small droplets forming gradually. Everything disassembled and connected directly…