🔪 HOZLY 3 Flute Carbide Compression Cutter - 175x17mm: Enhanced Precision and Efficiency Review

They are really impressive considering how much I paid for them. I bought them to cut half inch Baltic plywood. I expect they'll burn out pretty quickly given how cheap they are, but I was able to go through a few with a club before heading out to change. There were no breakouts on the top and bottom services so they worked great. I didn't push them too hard but it could be related to the performance of the router and not the bit. I will buy again.

I use Hozly compression bits exclusively for CNC wood carving of softwood and hardwood. I've never had problems with unexplained or premature failures, tarnishing or burning of parts. When I order a set of bits, I usually do a spot check with calipers to check dimensions and overall appearance. I have always found these bits to be as sharp and true to size as any of the more expensive bits I have used. As a small business, I appreciate the durability and quality of these bits without breaking…

I primarily cut 1/4" Baltic Birch in one pass. There was another reviewer for these bits who said they don't use tabs on their cut pieces so I tried a single pass with no tabs and for the most part it works if the waist shavings fill in the existing cut line. . With small details, this is problematic. For some reason, vertical cuts are better than standard (soft break) cuts for this operation. Feed rate 100 inches per minute at 12,000 rpm. Deviation from a straight path 0.004 inch. I can…