Header banner
Revain logoHome Page
inverter for plasma cutting svarog pro cut 45 (l202) logo

Inverter for plasma cutting Svarog PRO CUT 45 (L202) Review

1

·

Average

Revainrating 3 out of 5  
Rating 
3.0
Automotive, 🔧 Automotive Tools & Equipment, 🔨 Hand Tools, 🔧 Automotive Tools & Equipment

View on AmazonView on ЯM

Media

(5)
img 1 attached to Inverter for plasma cutting Svarog PRO CUT 45 (L202)
img 2 attached to Inverter for plasma cutting Svarog PRO CUT 45 (L202)
img 3 attached to Inverter for plasma cutting Svarog PRO CUT 45 (L202)
img 4 attached to Inverter for plasma cutting Svarog PRO CUT 45 (L202)

Description of Inverter for plasma cutting Svarog PRO CUT 45 (L202)

The Svarog PRO CUT 45 (L202) air-plasma cutting unit is a small-sized, easy-to-use and lightweight inverter machine for cutting sheet metal (almost any conductive material). The light and economical inverter device of the PRO CUT 45 (L202) series is designed for air-plasma cutting and cutting of metal up to 10 mm thick. The inverter boards are assembled on IGBT transistors. The device is equipped with a built-in filter - compressed air regulator. Easy high-frequency ignition provides comfortable work. The device is supplied with the built-in manometer for constant control of working pressure.

Reviews

Global ratings 1
  • 5
    0
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

There are several shortcomings, but, it corresponds to the norm.

I expected that from 197 volts under load the device would pull! Unfortunately, the solution is to buy a powerful stabilizer. Frequently reducing the air pressure for uniform operation of the plasma torch, I pay with a multiple decrease in the resource of nozzles and electrodes. Switched to svarog after the resanta ipr-40k. Which, in turn, was even more demanding on the voltage in the network. I did not feel the advantages of non-contact ignition over contact when cutting new thick metal. The…

Pros
  • Good assembly. Warranty 5 years. High-quality plasma torch (the torch of the cutter itself).
Cons
  • The instructions say that the input voltage tolerances are + -15% (187-255 V). In real life, at a voltage of 197 volts in the cut mode at the entrance to the device, the arc is already breaking, and the cut becomes intermittent. It is necessary to reduce the air pressure with the built-in pressure gauge by removing the cover of the apparatus for this. You have to do this often - as a result, a drilled hole in the lid of the device, and a screwdriver "registered" there forever.