🔌 16AWG Horn Wiring Harness Kits for Car and Truck Grille Mount Blast Tone Horns Review

The kit is very well made but unfortunately the negative cable is too short and I had to lengthen it to connect it to the battery post. Installation is easy. Connect the red + wire to the battery positive terminal and the black wire to the battery negative terminal. I replaced the stock hi-lo horn. I removed an existing horn (which was failing) and connected the + and - connectors to the wires that connected the stock horn. Connect both horns to the other 4 wires, 2 for one horn (hi/lo) and the

I wanted to update the horn on my daughter's vibe after she got stuck in the school parking lot and was lying on an original copycat Toyota Roadrunner. Finding this item along with "ACDelco D1918G GM Original Equipment A Note and F Note Horn" and "ACDelco PT2597 GM Original Equipment Horn Pigtail" was the perfect match. The vibe now sounds like a full size truck and I doubt it will be noticed again when the horn blares.

Update in the test! So if you are purchasing this harness with the intention of removing and replacing the stock horns then the instructions for this harness and harness in general are meaningless! If you are removing stock horns, the OEM horn connector (vehicle wiring) connects to the new horn terminal(s), then the second horn terminal only needs to be grounded as the OEM wiring already uses the relay and fuse for the OEM . There is no need to even purchase a wiring harness if you are…

I used this harness to tie a pair of Hella trumpet horns to replace one of the pathetic Roadrunner pancake horns on my 2018 Forester. The harness was more than adequate length; In fact, I left a few extra loops from the rolled up support legs. All wires are shielded with flexible tubing and all splices and connections are professionally sealed, as are the fuse and relay holders. The leads are 16 gauge stranded wire which is a lot heavier than the OEM wire Subaru uses which appears to be 22…