🚗 2015-2021 Dodge Challenger Front & Rear Mud Flaps - Kiwi Master Mud Guards Splash Flaps - Heavy Duty Molded Fender Flaps 82214141 82214142 Compatible Review

Pretty easy to install, especially if you have a flexible drill extension, which I did. Didn't have to take the tires off, less than 10 minutes each.

Took a while to install but no more dust, no more broken glass, not even a splash of water on the door or back panel! You do NOT need to drill the machine. Just use the factory drilled hole tight enough.

Very easy to fit just the bonnet to remove the rear tires come out the 3 holes in the back, front aligned 3 of 4 aligned also with no fitting instructions. any equipment as mentioned in the previous post

I like the look and it protects the paint very well. Installation on our Dodge Challenger took about 2 hours. I removed each wheel to install the Easley on the car, this takes a little longer but also ensures it is level and close to the car. You can't go wrong with this item.

I'm pleasantly surprised at how nice the fenders look on the car. They are the right proportions, not too big and not too small. In general the installation went well, I always do things a little differently than usual. For example I used push pins to attach them to the wheelhouse. I did not drill into the inside edge of the front fender to secure the top of the fender. I drilled a hole in the flap and pressed it against the plastic inner wheel arch.

Instructions were terrible and useless. It's cheap Chinese junk. They're not wide enough if you have 275 or wider tires. But they still offer good protection and work. I was able to install them without drilling or removing tires. Instead of using the top bolt for the front fenders, I used 3m of double sided tape (the same stuff the emblems are attached to). I still have no idea what or what the triangular plastic pieces are for. I didn't use them and the instructions didn't make any sense. I…

In my opinion if you have a claimant you need it. My car is 3 weeks old and has already had 3 paint scratches on the front wheel arches due to the big rims and tires sticking out so much which looks great btw. Destinations suck, but if you take your time and look through everything, you'll be fine. The fit was perfect, they look almost normal. I did as others have pointed out and put a clear vinyl underneath to keep the color from coming off which is listed here as a '3M bra' and sold in 1'…

Installed on a 2019 Hellcat. Fenders fit very well into the contour of the car. They were easy to install. Front Flaps: I only installed the bottom 2 screws, they seem strong enough. Rear fenders: I installed them without removing the rear tires. Simply snap the two rear fender mounts into place. For the bottom hole, simply poke a hole in the plastic fender liner. There is a pre-drilled hole in the body to match the hole in the fender. No drilling is required and I prefer not to drill holes in…