🚤 Kohree 12V Led Trailer Light Kit: Submersible Tail Lights & Wiring for Camper, Boat, RV - IP68 Waterproof Review

I like that they have spliced the wires on the left and right side instead of three wires where the daytime running lights wire needs to be spliced and one wire passed through the trailer. Plus, these lights are BRIGHT! The only thing I have to complain about is that the white ground wire could be a foot or two longer. Only about a foot long and will need an extra length to be spliced.

No matter who makes the light, pendants are difficult to rearrange. It is important to properly prepare the soil. The plugs supplied must be clamped very tightly, otherwise the connection will not be established. You could also install a few more of these clips to make adjustments to the setup. I didn't have to wire the socket to my car so I can't comment on that part.

Installed today. Our new trailer was already missing a rear light, so I decided to switch to LED lighting. I've run ground wires to each light to ensure a good, strong, reliable circuit. Boat trailers tend to get wet, leading to corroded connectors. Bad news for reliable reporting. I used these heat shrink/solder connectors to assemble everything. To put them together you need a heat gun with a reflector. They seem to be working fine. Time will tell if these hoses and connections are good in…

After a lot of work I think this trailer headlight set will be ok in the end. I would advise anyone to ditch the "quick couplers" and use wire nuts for all connections. And pay particular attention to the grounding of the lights on the trailer frame! I ended up using a piece of solid wire to get proper ground. Litze just didn't work. The light was very frustratingly dim (particularly the side running lights) until all connections (including ground) were very tight. But if you follow these…

This kit is designed for a small cargo trailer. Light materials seem fine, but as others have pointed out in the wiring, the white ground wire is very short. There are also four screws in the picture which I believe are for attaching the side lights, but there was only one screw in my package. Another thing I didn't like and wasn't aware of is that the license plate bracket is plastic. So if it hits something, it snaps off like a branch. It was labeled as corrosion resistant, which it…

The product is good value for money as the light is very bright and has a very good weatherproof look. This is an LED versus a regular incandescent bulb, so an extra ground hole needs to be drilled for proper installation. What I didn't like was the wire used, the sensor is very flimsy and broke every time I tried to crimp the connector so I used the supplied wire nuts which I don't really like to connect wires in the elements. . Also, the license plate bracket is made out of hard plastic…