🐙 Kraken Automotive 10AN Stainless Braided Hose: Ultimate Performance for Fuel, Oil, Coolant, and Air (10 ft) Review

Read a lot of reviews people say it doesn't fit their fitting the hose is falling apart obviously don't know what they are doing. The tubing worked fine as long as you knew how to cut it. Local stores sell the same tube for $8 a foot. I will buy again

This is the second time I've used Kraken SS braided sleeving. Good quality, used with Setrab fittings on one side and Evil Energy fittings on the other. Neither leaks and the hose fits well on both fittings. I would have no hesitation in purchasing this hose for any hair braiding needs.

Absolutely disgusting in the hose, enough dust and dirt, I have to spend a decent amount of time cleaning it before I'm comfortable, especially as it's after the fuel filter and before the injectors, my hose even came in a bag so it was before the item was shipped. I think during manufacture I first thought it was cut, but on closer inspection it was all the way through the hose. Be careful when using this for fuel injection. I wouldn't worry too much about rebuilding stock with a carb, but not

I bought 10ft of this hose and it was great to work with. I made some short lines and used most of the tubing. I tape the tubing before cutting to keep the ends from fraying. Then use the Koul Tools kit to install the hardware. This stainless steel hose was much easier to handle than the previous fabric hose. One of the stainless steel hoses is inserted directly into the fitting without using a Koul tool. The bend in braided hose is too tight, but these stainless steel hoses can be routed in…

When ordering this product, be sure to order the fittings of the same brand as the hose. I have made. And everything worked out. If you are unfamiliar with using braided tubing, be sure to watch videos online to learn how to do it right. I didn't have hose cutters so I used a Dremel cutting wheel; but be careful and do it fast. Too much heat from the Dremel will melt the material. I also had a small vice that I used to hold the bottom of the fitting while I screwed on the top. The video shows…