🔧 2-Inch Front and Rear Full Lift Kit Suspension Rise Mount Brackets - Compatible with UTV Polaris RZR 800 EFI Models Review

Wrong directions that go forward and that go backwards, small ones go forward and not backwards as the instructions say

Bought for my 2009 rsr 800. Installation took about 20 minutes and was very easy to do with a couple of wrenches. And it added the ground clearance I needed. Without spending 400 plus

This was installed on my CF Moto ZForce 800 Trail. To do this I had to sand down the edges a bit to make them transparent in relation to the controls, but in the end it wasn't difficult to install. For not even being made for my device, there's nothing to complain about. The price is very affordable for adding a 2 inch lift. Everything you need was in the box and the materials are very durable as it should be. Definitely recommend.

front end installed. Quite easy. I added a few extra washers to fill the gap that the spacers didn't fill. I'm removing the front stabilizer bar on my 2010rzr 800 so I need to buy some extra shorter bolts. The instructions say the smaller brackets come on the back. That is not right. You go ahead. The instructions are very general with a picture that is barely visible. However, I'm not sure how secure the rear setup is. Not much metal hole to support the mount. Gave me some headroom so I could…

Even though I had my shocks set to their hardest setting, I was so tired of my 2012 RZR 800 grinding against rocks every time I rode cross country. So I bought this cheap lift. Installation was relatively easy and only took about 90 minutes. The results were amazing! I set my shocks back to their softest setting and still managed to get between 1 and 1.5 inches of lift. Now my RZR cleans everything my four-wheeler does without feeling too heavy. I love the softer ride combined with the extra…

The kit includes tall and short brackets and depending on the year you can use either of them. Whether in front or behind. My application requires a long front. The problem is that the long ones are too long and the short ones are too short. I had to sand 1/8" to 3/16" of the bottom of each bracket and sand the corner back to the edge to clean up the weld on the arm. So this lift works, but be aware that you may need a little rubbing to actually adjust them. The sockets that fit between the…

I chose this kit with Revain's excellent return policy and am saving $200 on a kit guaranteed to fit my 2011 RZR 800 Walker Evans shock. It stood up great with shorter plates in the front and larger ones in the back. The bottom pieces are angled to fit over the welds. The entire equipment corresponds to the 5th class. After everything was assembled I inspected it around the block and then measured the stroke. Both front and rear were missing just 2 inches from 16 with the same spring preload as