🔌 1/4" NPT Inlet/Outlet Electric Universal Fuel Pump │ 72 GPH │ SP1130 P4070 Review

I give 5 stars to show it but seriously the threading on one side is so bad it leaks, unfortunately it's not even screwed in properly, I really need this. It's this part, so I have to redo it.

I downgraded the unit because it was a custom modification to replace unavailable OEM hardware, so no screw replacement was done. Works great so far, but only works for one day. Time will tell about the durability. The same item was available at a lower price in the order confirmation email, so buy carefully.

HAD NO PROBLEMS EXCEPT POLARITY. I COULD HAVE MISSED ANY SYMBOLS BUT THE PLACE WHERE I INSTALLED IT DID NOT HAVE TO READ THE BELOW WITHOUT REMOVING THE PUMP. THE PROUDS COULD BE SLIGHTLY LONGER BECAUSE IT WAS DIFFICULT TO OPERATE ALL THE SMALL DEVICES. I HAD TO RUN THE NUTS WITHOUT THE LOCK WASHERS FIRST AND INSERT AFTER TIGHTENING AT LEAST TWO TO COMPRESS THE RUBBER BUSHINGS. INSTALLATION OVER A WEEK AND NO PROBLEMS YET.

For years on the farm I lifted 5 gallon cans of gas to fill my cars. The older I get, the more difficult this task becomes. I've been looking for an opportunity for several years. I have a 12v pump for refueling diesel tractors, but gas storage and refueling are very different due to fire and explosion hazards. I looked at Revain fuel pumps. Being 12v and designed for gas seemed like a good choice. Unfortunately, even the high-pressure pumps were just over 30 gallons per hour, too slow to empty