Lisle 22990 Jiffy Tite 4 Piece Disconnect Review

This little tool serves its purpose! Use a mirror on the narrow spot under the lower radiator hose to see the transcooler fitting. There is no way you can get in there with a small master key and remove the retaining bracket. • First clean the mounting area with brake cleaner. • Remove the plastic latch cap with a small flathead screwdriver. • Apply some WD40 to the fitting/pipe area. • Install this tool on the pipe with the lip toward the fitting, close and insert about 1/4 inch into the…

Works great! sooner or later. I will need it. and of course I HAVE. I had a Buick Century 02 with a bottom line leak due to a bad o-ring in the dash. There was NO way to get there to drain the water from the cooling system, remove the lower radiator hose, fan assembly, etc. to gain access. Lo and behold, removing the bottom panel gave me access. flashlight and mirror. After removing the clamp holding both trans lines for support I was able to work blind with this tool and remove the matching…

The storage case is well made and should last a long time. The tools are also decently made and should last a long time if not abused. However, the bar that acts as a loop doesn't fit snugly and allows for quite a bit of side-to-side lateral movement. Also, the surface was deburred and slightly warped on the sharper edges where the tool enters the fitting. I had to clean up those edges before I started using it. The first two photos show some ridges. Look for sharp edges to see burrs. Sorry the