🚲 LITEONE MTB Stem: Adjustable 90mm/110mm 90° Short Mountain Bike Handlebar Stem for Bicycle, Road Bike, MTB, BMX, Cycling Review

The LITEONE MTB Adjustable Stem is amazing! I'm 6'3" and they raise the handlebars just enough so I'm not as heavy in the front. Makes trails a lot more fun. You get a lot less tired.

The nut you tighten is only available when the stem is folded. So you need to set it up in the folded position, tighten it, and then adjust the angle. I just learned by trial and error and turned it off too many times. Make sure you line it up and face forward before tightening. Once assembled, it offers a comfortable ride so you don't have to bend down.

I wanted to try and sit a little more so I bought this adjustable stem for my FatBike. I have smaller handlebars so I had to order a set of 25.4-31.8 bar washers. They worked great. The installation wasn't that difficult at all. You just have to keep working to make sure everything is fine when you're done. Then we tighten everything. I am very happy with the height adjustment. Simple and an inch was very important. It even looks great on my bike.

First of all: Versatility sets this stem apart from others. The handlebars of my new gravel bike were too low and hurt my lower back. Unfortunately, bike manufacturers sell forks that are too short for some. This stem feels massive and solid but is very heavy. To be fair, non-adjustable stems are much lighter due to fewer materials. I plan to experiment with cheap adjustable stems until I find the best length and angle. This barrel was perfect in every way.

I installed this on my e-bike by replacing the factory stem. I wanted my handlebars to be higher for easier recreational riding and also so that my son would have a better grip when in the MTB shotgun child seat in front of me. Installation wasn't easy right off the bat, mainly due to the lack of an included instruction manual. Basically I had to take it apart to fit my bike but when all was said and done it was very sturdy and has more height.

I wanted to raise the handlebars on my new e-bike so I replaced the stem with this one. I was able to increase the height by about 2-3 inches and get her a little closer to me. This allows for a more upright seating position, which I was looking for. If this part has a fault, then it is slightly heavier than the one it replaced. If you're counting grams or ounces, this may not be the case. But this e-bike weighs 72 pounds, so I'm not worried about putting on a few extra grams. In general it…