💪 Macho Rev C Revision Review

With its pros: Cooler is definitely good. r9-5900X at stable 4200 temperature up to 70 degrees. Some cons: Nowhere does it say that it is not suitable for miniITX boards. If you install this cooler, the kit simply won't fit into the case. And since it has already been printed, they will not accept it back from you.

Great cooler for the money, but not without problems. The pros and cons are described above. I use in pair with intel i7 11700k processor and mx4 thermal paste. The hourly stress test prime 95 runs with a maximum temperature of 87 degrees. Its pros: Quite a massive heatsink, not very noisy cooler, fits into a 160mm case, good equipment, which consists of: a cooler, a 180mm fan, assembly instructions, as well as assembly material for all compatible sockets and a high-quality screwdriver. In…

I have already put several such bags on stones under acceleration from 3770K and 4770K - to modern ones. For the money - it copes perfectly well, there are no complaints, there is not expensive thermal paste in the kit. I never fooled around with leveling the "heels" - I set it as it is - everything works fine, the temperatures are normal (I had a maximum of 82-86 with 4770K and 4.5 GHz) it works quietly - the quietest cooling element in the case. I used to fool around with dropsy, then I…

Frankly, I’ll say worthless brackets (their design) for attaching the fan to the tower. The B version is much better. I got tired of putting them, when installing them, they bend and they pop out of the groove. The site has a small depression in the middle. If you want to reduce it with a knife, you want to smear a little more thermal paste in the center. Knowing about the uneven area, the manufacturer could have put a little more thermal paste in the tube.

I did not hand over the cooler, I finalized the plane. In some places, the nickel layer has gone, the copper base has been exposed. Check the clamping of the platform upon receipt of the goods on a flat surface. Different pros: Everything is beautiful: packaging, metal quality, quiet ventilation. The product outwardly makes a good impression, I am sure that it will cope with the task of cooling the processor. Some cons: Humpbacked platform! The backlash along the plane is almost half a…

This cooler is big. The 140mm fan does a great job of keeping temperatures down and with 6 heat transfer tubes, big numbers fall off quickly. t are properly attached to the processor. We contacted the manufacturer and they sent replacement parts for free! It worked well even without the right fit, but now that the right contact is made my temperatures have dropped a lot. I'm seeing idle temps of 40°C and maximum load temps of around 73°C on my Ryzen 7 2700X.

Lightweight, high quality air cooler works with AMD and Intel sockets, Thermalright has made it back to a brand you can trust. (each at least 1 hour test) CPU and FPU Aida64, Prime95 26.6 @ 5GHz 1,260V LLC High with 0 avx offset, Z390 Aorus Ultra board stays in the 76-82C range Good screwdriver and a pair of gloves (antistatic I don't think so really safe) and all AMD and Intelcon socket mounts: installation instructions could be better. QA: Is your 8086K rotten? Does the cooler come with…

I was dying to find a large air cooler for my 9900K that wouldn't block my RGB lighting. The Thermalright Macho line of coolers were the only ones I could find that provided this. The installation went well, I used the MX-4 instead of the supplied thermal paste and checked the temperature immediately after booting. In a panic, I had to switch off the system immediately because I was only in the bios at the time. After removing the cooler and looking at the contact pad it left on my processor, I