🔊 MagnaFlow 4x9 Oval Center/Offset Performance Muffler Exhaust 11224 - Straight-Through, 2" Inlet/Outlet, 14" Body Length, 20" Overall Length, Satin Finish - Classic Deep Exhaust Sound Review

Great exhaust. I installed this on my 2013 Hyundai Veloster NAV. I was disappointed with the sound at first, but I reset the ECM (disconnected the negative battery post for a while) and the sound really worked. Every day I ride it, the sound gets deeper and deeper.

Nice sound as you would expect from a straight through muffler, depending on the sound or exhaust system you have it is just there to enhance the sound that is there. Sounds great on my 87" Corolla with a 4 year old engine with a high flow catalytic converter. There is no noticeable gain in performance, only sound.

Installed on a 2004 Ford Crown Victoria. They sound good, a bit more boomy than stock mufflers (which unfortunately are lazy, you know). They sound a little better once they've been played in, but they're pretty harsh. They are about 8 inches too short to serve as a direct replacement, you will need to use a test tube or something similar.

I bought it to make my car quieter. Before that I had a regular double glazing window and it was too noisy. This muffler strikes the right balance: It's a bit louder/sportier than the standard muffler without being annoying. I relocated this muffler to try and match it to the stock layout, but I think a center intake/exhaust would work better. In general I am very satisfied with the sound and quality.

I bought this muffler to replace the stock muffler on a 1998 Mercedes ml320 although it's a six cylinder Magnaflow which makes a nice deep growl when you stand on it but no unpleasant noise in the interior cockpit or rumble on the highway. At a price you can't go wrong on Amazon, I had a muffler shop install it as the stock muffler was double on one outlet (very hard to find a decent aftermarket alternative) so the shop built a custom one Y pipe adapter, the muffler that went with it and to…

I installed it on my Miata 1.8 2003. First I welded the intake, not the exhaust, to the exhaust pipe, then I took it for a test drive and I really liked the sound, it was a little hum but very smooth. After a test drive I welded the exhaust, it became quieter and now there is no hum. It's louder than stock, and if I listen closely I can hear the exhaust popping when the top is down. I wanted the sound to be deep with no buzz and really hear my exhaust. This silencer did all these things, can't…