🚐 MICTUNING RV Exterior LED Porch Utility Light 12V 750 Lumens Each, Replacement Lighting for RVs, Trailers, Campers - Pack of 2 Review

Wish they were bigger so they could be a direct replacement for an old style RV porch! I used two to replace my one light fixture. They are a huge improvement over the factory yellow porch lenses. They light up quite a large area of my garden.

The light itself is great! As mentioned in other reviews, the flashlight itself is not a direct replacement without modifications. Use of original screws, not supplied screws and nuts! I could turn on the headlights. But as seen in the pictures, the screw holes and power cord hole were once removed as they appeared and the outer part of the lamp and the old screw holes must be silicone to make it fully waterproof.

Great little flashlight, two of these outside my gated trailer that we use for camping. Bought another one for the back. I think my only complaint would be that it is unsealed on the back and has to come with a plug for the other side. Where the wire comes out because I routed the wire right behind it. But silicone didn't fix anything. The lights are good and bright. The construction is heavy. I would recommend them and I will be buying more

My motorhome didn't have porch lighting instead of an LED strip running along the canopy, but this is a design flaw that cannot be used when the canopy is closed. So I connected the wire and connected it to this light. I glued the velcro to the wall. It works amazingly well. It will temporarily blind you if you look directly at it. It's so bright. You don't need any other light when using this. I like the light, but some people like the cozy and feel too light. I'm happy with that.

This is the second Mictuning product I have purchased - the first was a pair of LED side arrow lights fitted to my commercial lawn mower. I had a good experience so I decided to try Mictuning again. This pair of lights is designed for a 6x12 enclosed cargo trailer. Holy cow! - They are bright and give more than enough light. The body is very strong. Just a well made product. Easy to assemble. Whenever I need a 12V light I turn to Mictuning first. I recommend your product.

The lamps are nice, bright and well built. A couple of issues I have right out of the box is not RV friendly lights as they are attached and plugged in. What kind of van lights have you seen where the wire exits the side? No one. And what kind of camper can you put in the wall with bolts to turn on the lights? Most RV lights are bolted to the side of the trailer rather than bolted. I assume they come with double sided tape? What's it like to either swap out the studs for screws or use duct…

Good low profile light for a converted cargo trailer. I ended up putting the wire in the back and filling the hole with caulk. It would be nice if it was like this from the factory. The rubber plug fills the hole on one side, but I think they're assuming you only need one because the wire comes out the other side. In the case of surface mounting, the wire must emerge to the rear. I didn't use the included hardware, I bought M8 stainless mounting bolts that fit the existing holes and riveted…