🔌 Molex Micro-Fit 3.0 Dual Row (4 Circuits) Receptacle Plug Set, Male & Female with Terminal Sockets, Pack of 5 Sets Review

High quality. Easy to use with standard cutting tools. The pins are strong and very durable. The plastic case is also very durable.

I only have 4 plus plus only the male ends were included. I can deal with the missing connectors but without pinch ends they are useless to me.

Molex is the industry standard for this type of connector. It's been around for decades and I can't think of anything that could be changed for the better. A simple product that does what it is designed to do, with good factory support and literature.

I needed a couple of these for the 3D printer I was hooking up, I could buy somewhere like Digikey or Mouser. But overall they were cheaper considering the premium shipping. I bought a microfit kit elsewhere but they didn't have a 4 pin 2x2 so I got these. They were genuine and the same quality as the ones in my kit. You will need crimping pliers for this. I used IWISS IWS-2820M AWG 28-20 (B078WNZ9FW) crimping machines and everything went fine.

I've made a lot of cable assemblies in my time but these are some of the best but also the most difficult. There are several videos on You-tube that will give you an idea of how to crimp pins. I've encountered a few problems. It's not clear what the PIN numbers are, as far as I can tell you can create whatever PIN you want just to stay consistent. I found a chart that made sense to me and used it. The second is the outlet, I found the information on Molex.com and attached the picture. Don't…