Moog K200044 Control Arm Bushing Review

These two new kits are ordered from Revain along with other Moog items. These bushings were badly rusted for an item that was supposed to be new. Personally, I'd rather pay a few bucks at an auto parts store if they can guarantee I'll get a quality item.

Appears faithful to the original. Removing the old ones was a real chore. The press kit could not get everyone. So push out the rubber section, then carefully use a saw to cut a slit on the inside, then trim off the outside edge and it should release enough pressure to remove. I put a nut and some washers between the lever flanges so it stays about the same when I push the new one in. Looking back, I welded some steel supports. As you press the 2nd, measure the overall width and try to stay as…

Fits a 2003 GMC Sierra 2500HD 6.6 Duramax. A trick to make this setup super easy: Tools: Oxy/Ace torch set, Sawzall, large bushing bushing, hammer, air chisel, gloves, steel pipe wider than the inner bushing hole of the wishbone, and a pot of water. . Use a flashlight to heat the old socket to melt it. The outer metal ring of the hub remains pressed into the control lever. Then use the saw to CAREFULLY cut through the steel bushing of the old bushing that is still in the control arm. DO NOT cut