High-quality MotoFab Lifts CH-2R 2-inch Rear Leveling Lift Kit Compatible with Chevy Silverado Sierra GMC 2007-2018 Review

Very easy to install and hold the lean angle on my truck with a 2.5" front kit. The blocks have a slight built in angle, be sure to mount the smaller block towards the front of the car if your springs are higher than the axle. The welds on the parts looked good, the finish looks good and I particularly liked that. The U-bolts are fine-threaded for strength.

Very satisfied. Very high-quality workmanship, with protective coating. The hardware appears to be as good if not better than the OEM. Installed on a 2015 Chevy Silverado Crew Cab with 6.5" bed. I used to mount my 2" leveling blocks up front and after this rear setup I got an inch positive front angle which I wanted so the rear isn't lower than the front wheel with the trailer attached. Installation was easy, taking an hour per side with just a socket wrench, jack and jack stand. Make sure the…

This is a good and economical option for raising the rear of your Silverado. This is actually the most common way of raising the rear of these trucks. Even if you look at really expensive lift kits, they still use blocks for the rear. I paired this set with a Rough Country 2" Front Alignment Kit. I wanted to keep the factory frame (rake), just make it a little taller. The truck looks great and as far as I can tell there are no real problems. with quality on every lift kit. Installation is easy…