🔧 Motorcraft FG-1114 Fuel Filter Assembly - Set of 2 (2 Pack) Review

Ford appears to have renumbered their part numbers as I use a 986b filter on my car. However, I checked Ford's website and found that this is a new part number for my Town Car's fuel filter. The new filter fitted well. I regularly change all my filters for new OEM filters and now my car has 492,000 miles on it.

Easy to attach. This was for a 2008 Ford Crown Victoria. You will need a 5/8 tool to remove the fuel filter. I recommend one made of plastic, not metal. Do not remove the white clip on one side. This is done to push and the filter is released and stays on the line. No need to remove the white clip, no need to buy plastic fuel line clips. Be careful with this.

Was the same as the one I took off the truck and most likely the one I took off the truck was original and had 200,000 miles on it. I only wanted to change it because of the mileage of the car. No issues worked as described and from what I've read the development of this factory OE part is unlike any other that would fit. That's why I bought this filter. Used on 2000 F150 4X4 Lariat.

Don't go wrong with OEM filters, this filter takes about 5 minutes to replace. Just make sure you have a tool to disconnect the line, otherwise it's difficult to replace, there's one plastic tab (the white tab on the left) that you have to pull out and the other you use the metal part to maneuver and out need to clear the way so the line break tool to open pushes the seal so you can pull out the filter. Be careful after turning off the gas

Before I changed this fuel filter on my Grand Marquis I felt like I was going backwards most of the time. I mean, my car was so slow that I pulled out of the driveway and my toddler drove past me in his little car. Now that I have this Motorcraft fuel filter, I can drive through the tires faster than Dale Earnhardt Jr. airplane speed. This filter works!

Application: 2006 Ford Crown Victoria Police Interceptor I have been using K&N PF-2000 fuel filters for 4 years and replace them about every 18 months or 30,000 miles as recommended by Ford. I finally settled on the Motorcraft FG-1114 (2M5Z-9155-CA) fuel filter and am not disappointed with the quality and construction. Although I can't say for sure if Motorcraft is better or worse than K&N. , Regular filter replacement is cheap insurance and costs less than an injector kit or fuel pump.

I bought a v6 '99 Mustang for a very reasonable price but it didn't work. I went with this fuel filter and replacement fuel pump and now it works. Filter, it looked like the original for the car. When disconnected, a small amount of clean gas came out of the front of the filter and black dirt came out of the back of the filter. This filter snapped easily into place, just like it came with the car from the factory. Only time will tell how long this will take, although I plan to complete all…

People forget the fuel filter and modern gasoline is so good and clean that it doesn't usually need to be changed too often. Usually. I've changed it three times and the first two it still worked great and clean as a whistle. The third time, however, he was severely beaten. 30,000 miles each time, which surprised me the third time. You'll need these small filter removal tools (available from Revain) and safety glasses. Googly swim. For some reason when I remove this filter, my F150 sprays a few

This filter does not come with the plastic clip you need for one side of the fuel line. You can buy them at an auto parts store but if you buy this filter at an auto parts store it comes with 4 or 6 clips, I don't remember exactly but you only need one. On the other side there is a permanent clip built into the fuel line and you will need to use a tool to disconnect that side. From now on I will buy this filter in the parts trade or from the dealer. If you are very careful and the old clip has…