🌊 Smart WiFi Motorized Ball Valve Watering Timer - Automated Electric Water Shutoff Controller Robot with Tuya Smart & Smart Life App Control, Compatible with Alexa - No Hub Needed Review

I can see this thing working and it's a good thing but the mounting bracket is far from enough for a 1" NPT valve You have to make your own mount to make it work The fork, the built-in plastic mount on the opener body, is probably too weak because the opener puts out a lot of torque somewhere.

Physical installation was fairly easy. In fact, however, it does not block the water valve. It is fitted at a slight angle and the pins for turning the valve are too short - so they slip off the valve! When I move it, the ring around the tube becomes too small. There is no information in the package on how to contact support. Since it didn't work, I didn't try to connect the app.

Actually couldn't avoid installing it on the valve. The product seems to be of very good quality, works as it should, but both apps are junk. The Smart Life app finally connected to the device after two hours, but when setting up the programming it was only possible to turn the valve on, it won't turn off unless done manually. , the TuyaSmart app will not pair with the device at all. If you could find a good app to turn it on and off programmatically that would be great.

We installed it at the bottom spout of our water tank. It is an elevated reservoir with a fill line from the city and a second line feeding the house. We ran out of water in town and they turned the water on or off whenever they could. When I went outside to turn on the faucet, since there was no city water, I feared that the tank would overflow when the city water came back on. Backflow protection didn't work on this application so I installed this device. Now when we need water, all we have…

This drive is pretty good when configured properly. In my case I had to cut off part of the mounting bracket to mount my 3/4 inch water valve and add a bushing to the valve stem nut and actuator nut to hold the actuator in place as the bracket was too flexible . allows the movement of the shafts when opening/closing the valve. The app works, but is a bit cumbersome. Update: The drive now shows as disabled and I can't reconnect to the router. The instructions are confusing at best. I'll keep…

Based on ESP8266, with 2MB Flash. Gears and all gears are metallic as far as I can see. Has enough torque to drive most thrust valves. 90 degrees. Now for the issues: while the main arm is metal, it sits in a simple hole in the ABS body. I assume it will wear out sooner than it should. There are no reviews. A mechanical polarity setting relay cuts power to the motor at the ends with a single signal from the ESP and the limit switches. The board is installed on the limit switches, nothing else…