🔌 O-NEX LED Resistor Kit H11 (H8, H9): HID Relay Harness Adapter for Flicker-Free Lighting with Error Decoder & Warning Canceller Review

First of all they are not very well made. Parts that match the vehicle's original wiring are oversized and not identical. One side fit but I had to press it (causing the metal pins on the original wiring to bend) and the other didn't fit at all. I would have to damage the original plastic connector in the hope that it would work. Second, the resistors got too hot and started to melt after 10 minutes of operation, and the wiring is too short to screw to solid metal. Finally, yes, that solved the

This wiring harness does not fit the front turn signal hole on my 2019 Nissan Frontier. You need a 7444 bulb. There is 1 pin different from the standard socket compared to the new socket. All I did was take a flat file and cut off one of the thick pins on the new bushing and it fits. Feels good there. I'm only giving 3 stars because they didn't fit properly without modification. The resistors fit perfectly for my LED turn signals. They get VERY hot, hot enough to burn you. Make sure you mount…

Let's start with what everyone is looking for: the bad. The bad thing I found is that you may have to provide your own large zip ties. Also find a place to mount them so the resistors don't cause heat dissipation problems. Yes, the resistors are HOT. don't burn yourself Now for the good. I have a 2002 Ford Escape that I replaced the headlights with LEDs. When I did the swap I stopped using my fog lights and I didn't have a high/low beam indicator on my dash. I put 1 of 2 sets in line and again…

Switched to another hid company and the new ones I replaced caused clicks and then completed one way crap and after reading and talking I was told that I'm going to need Dodge a special hidden wiring harness that can cost up to $150, I'm not going to do that because I know ways and that's where these resistor adapters come in handy. I only needed it for one side as the hidden wiring harness only plugs into one side but then again it's dodgy and it has an annoying lightbulb that won't stop…