NOCO GC002 Eyelet Terminal Connector Review

This spade lug uses a smaller 10A fused wire than the Genius10 (10A) 20A fuse wire. So this spade lug is useless to me as I have a 10 amp charger . I contacted NOCO about this. They told me to replace the 10 amp fuse on the spade lug with a 20 amp fuse like the one in the charger wiring. Because this connector has a thinner wire, it could pose a fire hazard, so I won't do it. If you have a 5 amp charger or less this connector can be used, but for me with a 10 amp charger it's useless. I read…

My motorcycle (2004 Yamaha FZ6) has a battery that really isn't available. To get to the battery, the fuel tank has to be lifted up, which is quite awkward when charging the battery. Years ago I custom made an old charging cable to connect a charger, but last year I bought two NOCO chargers and wanted to use them on my bike and the connectors were different. Looking at Revain I saw this adapter and it seemed perfect for the task. Of course it was wonderful. The posts were the right size for my…

I accidentally ran out of battery once while leaving my keys in the garage during the day. My battery wasn't easy to get to, and it didn't have "pillars" to connect a car battery. So I bought them and screwed the cables to the battery. The only negative was that it was a hassle to screw them on, but that was my battery's fault. Due to the design of the compartment that housed the battery, I had to bend the connector pins slightly to match the cover. reliable connection to my battery from the…

I will keep/use this accessory for my charger but I'm not a big fan. I'll admit it's well made as described (I like the protected protective case for the charging port) but I had hoping for one. more. As another reviewer notes, the eyelet connectors are too small. I was able to use one - with a cable stud + battery terminals, but the side stud (-) was too big. I had to cut the eyelet end of the connector and "catch" it in place. It's not hard to do, but tedious. I wish the overall length was…

I bought a NOCO Genius GC002 connector for a portable solar panel project for my caravan. I like the well made eyelet terminals for the battery as well as the built in fuse holder. I installed an SAE panel flange connector on top of the battery box, cut off the factory NOCO connector and soldered the two wires together with solder butt connectors. Now I can connect the trailer wires along with the solar connector when the battery is installed and attach the cover. No more removing the cover to…

Great for an easy way to keep your bike serviced or charged when you can't ride. I was able to easily attach and close the battery cover, slide it over the connector and tuck under the tank when not in use. I wish it was a foot and a half longer so I could put it in my windshield pocket to make it easier to charge my phone, just like my last one, but I've been spoiled. Now I'm waiting for my NOCO GC009 X-Connect so I can use my BikeMaster SAE USB connector until NOCO makes a USB connector with…