Nozzle, Round, 🔘 1.6mm x 3.0mm Dimensions Review

FYI yes it has a hole that was just neatly plugged with solder. Attach, heat gun, wait for it to melt, pull the trigger, viola!

This tip does NOT fit the Hakko FR-301 desoldering tool. When I sent this back I found that the correct 1.6mm tip for the FR-301 is N50B-06.

Hakko manufacture top quality soldering and desoldering tips. I have an absurdly long lifespan from their soldering tips and I expect nothing less from them. Great product - wish I had found it years ago!

This tip is suitable for FR 301 HAKKO DE soldering tool. Someone wrote that it doesn't fit and I received it yesterday and it fits my FR 301 OK. I am posting this as there has been some controversy in the reviews. GOOD LUCK BP

I was looking for tips on my Hakko FR-300 and found these tips. They are not suitable for FR-300! The typical Hakko is constantly changing something that has no clear definition. Be extra careful when ordering Hakko spare parts!

I don't know what the other reviewer is talking about, it's the same nozzle that comes with the Hakko FR-301 desoldering tool. I don't work for Hakko, I just bought and returned two other tips based on a reviewer here who said this tip is incompatible if it is.

Yes. It's true that the N61-10 tip fits the Hakko 301 desoldering gun! Just go to the Hakko website and check it out. Not sure what other people are getting or using but this fits and works great on myFR-301. I was very confused by the mixed reviews but I made the right decision.

N61-10 should have a 1.6mm hole. Maybe I'm just too stupid now and didn't look at the picture. Do you see the hole in the nozzle? I didn't see any holes in the injector. Luckily 1.6mm is almost exactly 1/16". So I put the nozzle in my lathe, lined up the end and carefully drilled a hole. Now it works fine. I need a bigger hole to fit through the legs of some of my to go crystals must be removed from the oscillator board.