🖨️ Nozzles Printer Extruder: Makerbot vs Creality - A Comparative Analysis Review

Always buy injectors from trusted sources. I bought them because they are so cheap and seem to have good reviews. I was new to 3D printing and randomly ran into problems. I replaced my extruder, my motors, added auto bed leveling, replaced ALL HEAT, I even changed the nozzle a few times, everything seemed better after that, but not for long! After learning more and more and now trying jets from more reputable sources I can say with confidence that these jets are complete crap, I threw what I…

I really like these tips. A friend recently recommended me some high-priced hardened steel nozzles. 2 x 0.4 nozzles for $30. And I absolutely hated her. They kept clogging and the print quality was unpredictable at best. I threw them away and went back to those brass fittings. These tips wear out quickly with each abrasive fiber. But that's to be expected from any brass nozzle. However, the print quality is good enough and they're cheap enough to throw away after a few weeks of use. It's the…

Don't trust these baits. Wanted some 0.4mm bits and it looked like a good choice. Every nozzle I used was clogged. The alignment test and temporary tower were fine, but halfway through my test print it kept clogging or dripping, and what little that printed looked like it was covered in cobwebs. I figured it must be thermal creep because I had clogs that went all the way to the Bowden tube replacing part of the hot end. nope I heard a knock from my extruder and switched to a Creality all-metal…