🚚 Nstarsmotor Truck Tie Down Anchors: Ideal Replacement for Ford 2015-2021 F150 F250 F350, Boxlinks & Tie Down Plates (4 Pack) FL3Z-99000A64-B, FL3Z-9928408-AB Review

Easy installation. I recommend putting some anti-seize compound on the threads of the screws during initial assembly. Screw in a little, turn in the opposite direction, then repeat until the screw is snug against the bed wall. Drill all 4 holes, then attach the anchor plate. I used an impact wrench and axle grease.

Works as advertised. To install it you need to buy faucets as described in another review. I had a small problem with one of the modules, but the seller was very responsive and quickly sent me a replacement. The material of the product is good and it is easy to install by pressing first.

I bought it as a Christmas gift for my brother-in-law. A year ago I also bought a kit for my F150. Nice snug fit and no rumble, not to mention a great attachment point at the back of the truck. All 4 cable ties have the same keys and you will receive 2 keys for each cable tie. If you ever lose your keys, it's only your fault for putting them in one place. Seriously worth the money

This product is easy to install. First apply lube to each of the holes on the truck plate where you will be installing the bolts. Then use a cordless drill to tighten the screws. Let them in a little and then turn them back to get them out just one turn and finish screwing. Use a cordless drill. The cordless screwdriver does not have enough power. Don't overtighten. The product works great. The photo shows how I used synthetic blue grease to pre-lube the hole. Installing four of these devices…

I carefully installed 1 mounting hook. Each screw is properly seated and well tightened. The second hook is not very good. 1 of the screws turned freely. I went to the third hook and couldn't get any of the screws. That's when I noticed that the threads were flattened. I started removing the other hooks when they were pulled out with enough force. Of the 8 screws for the 2 built-in hooks, 7 had flat threads. I put a 1/4-20 in one of the holes on the truck and it worked great, but now I have to…

I couldn't use the included screws to hand cut the holes. No force will work to break the screws. For those who want to know, you will need to use an M6 x 1.0 tap to create threads for the screws to fit in and snugly fit the panel assembly. For those with plastic coated inserts, all you have to do is pull the side of the inserts away from where you need to install the panel and tap into the holes with a small wrench, e.g. B.: Tap Holder Wrench + 5 pcs M3-M8 Machine Thread Metric Plug Tap) When…

UPDATE>>>>>>Seller confirmed some of the screws were defective and sent me new screws which worked as expected. Anchors is exactly what I was looking for (finally installed)! The first rating was 2 stars Anchors seem pretty strong but I really can't tell.1. I ordered from this supplier because they showed blue locks to match my truck but I got 1 blue and 3 silver. But I didn't understand what is shown in the picture.2. I must have received an old package as the screws are NOT…