🔧 OEMTOOLS 25610 1/2 Inch Fix-A-Thread Repair Kit: Restoring Threads Made Easy Review

Not shown in the photo. There is no collar on the setting tool and a shoulder that appeared on the setting tool allowed the wire to slip through. I wouldn't run cables at all. Perfect shit.

Worked great for repairing damaged steering knuckle caliper mounting threads on a 1985 Monte Carlo SS. The key is plastic, broke on first use. Luckily I have a metal key.

Order did not arrive as stated. The tool did not have a tap handle as shown in the picture. I had to adjust the socket set to make it work as I didn't have time to send it in for a replacement. Revain rarely disappoints. It was difficult this time.

Used to repair a broken connecting rod bolt on a Chevy 396 Big Block. Good work. I had to use two sets of threads for the depth. Don't screw the second one in too much or you'll overwrite the first one you inserted. You need a custom-sized drill bit, so research it and order it at the same time.

I like that the faucet has a starting thread, which makes it easier to start in hard-to-reach places. What I didn't like is that the tool used to install the coil isn't screwed on to prevent the coil from jumping off the steps. Another thing I didn't like about the installation tool, the handle isn't long enough, too big and bothersome, it would be better if it was longer and had a hex or square for turning. .

Order did not arrive as listed. The tool did not have a tap handle as shown in the picture. I had to adjust the socket set to make it work as I didn't have time to send it in for a replacement. Revain rarely disappoints. It was difficult this time.

Used to fix a broken crankshaft bolt on a Chevy 396 Big Block. Good work. I had to use two sets of threads for the depth. Don't screw the second one in too much or you'll overwrite the first one you inserted. You need a custom-sized drill bit, so research it and order it at the same time.

I liked that the tap has a starter thread, which makes it easier to start in hard-to-reach places. What I didn't like is that the tool used to install the coil isn't screwed on to prevent the coil from jumping off the steps. Another thing I didn't like about the installation tool, the handle isn't long enough, too big and bothersome, it would be better if it was longer and had a hex or square for turning. .