🔪 Optimized Olson Saw SP46100 Spiral Scroll Saw Blade Plain End, 0.032-Inch, 46 TPI Review

I cut 1/2 inch thick soft pine. I used almost the entire package for three cuts. They break very easily, maybe good for plastic.

Love love love those blades! Yes, the coils are a little trickier to install, but if you pull them tight enough and maintain the correct tension, they'll be a scroller's best friend!

If this is your first time using them if you haven't tried spiral blades then at least this is a good starter set and you should at least try them.

Cuts excellently in any direction and leaves a very thin kerf. I use them with a 5 inch dovetail jigsaw. They work great and last a long time. I strongly recommended her.

These seem to be good blades. You are very thin. I've broken 2 already. I'm new to using this type of blade. My edges look wavy. I'm sure with practice I'll get better at cutting with them.

It's torture to sit down and blow. Once you do, oh my god, it's pure love for the spiral saw. I pushed these blades into 1-1/2" x 8" treated greenwood to carve a fish, it was amazing how well they did it. They cut 360 degrees so you don't have to worry about hard-to-reach places. I've noticed that they seem to stretch a bit more than a regular blade, for the first 15 minutes I had to pause to tighten the blade adjustment 4 or 5 times, after that it was great.