🔧 High-Performing Performance Tool W54247 Grease Fitting, 6mm x 1mm, 45⁰, Pack of 10 Review

Very good quality but I couldn't use it because it didn't fit on the mandrel of my Husqvarna lawnmower. The correct size is 8M. To return.

I needed 90 degree grease fittings to allow easy access to the Moog inner tie rod ends. 1/4-28 was the correct thread size for the tie rod ends.

I received these to replace the needles on the JKS Away circuit breakers on my Jeep. Worked great and the old ones were such a flatbread I'm willing to disassemble and replace over and over again that gave me five sets.

Don't waste your money and time. They all flow. Some flow at a 90° angle, others flow back through the spring hole. I used 5 of these, each leaked. I'm waiting for another brand to take it off and send it back. waste of time and money.

Perfect for replacing a broken Zerk fitting on one of the Bearing Buddy bearings on my boat trailer. In order to replace the mirror on the bearing partner, you must remove it from the wheel hub, as there is a nut inside that does not allow you to screw the mirror on from the outside. This is easily done by tapping the Bearing Buddy on all sides with a hammer until it comes loose. After that you will need two 5/16 sockets to remove the old plug, one for the plug and one for the nut inside the…