🖨️ Enhanced Printer Filaments: Unmatched Durability for Resistant Printing Review

I used this with my Ender 3 v2 as an oil can (with rapeseed oil) for my all metal hot end which I know is a bit controversial. I've used this with both 1.75mm pla+ and 92a TPU flex filament. Both worked without problems. The main disadvantage is that you can only insert filament through the foam, it really needs to be disconnected so you can attach it to your filament without having to reset the printer. I have since modified it by cutting the foam with a knife but this should be taken into…

Generates some filament drag but not enough to affect print quality. The foam inside only has a straight hole and is not split like a body, so you can't just pinch it in the middle of the print, you have to pass it through the hole in the middle of the foam when loading the filament. I only cut half of the foam so it can be attached in the center of the print. It definitely cleans the filament as it goes through, as you can hear the foam creaking as the extruder pulls the filament through…

These are great little filters and you get so much for so little! I use them on all my 3D printers, both dust filters and oilers (avacado oil for higher print temperatures, vegetable oil works too but has a lower smoke point). They work great with PLA and PETG to beef up the hot end for a few dozen prints and when they wear out I put a new one in with just a few drops of oil and it's back in business. I only use 1.75mm filament. , but 3mm fits well, the housing has large holes at each end and…