🛏️ Ender 3 - 235" Tempered Glass Print Bed for 3D Printer Review

This is a steal at $25 for two pieces of flat glass perfect for the Ender 3's bed. I used chemical etching on the surface of one side of the glass to give it a "tooth" for adhesion. So far this has worked very well. For the few pieces that take up most of the bed surface, I still spritz on a light coat of hairspray for reassurance. assuming these are all 8-12 hour prints with a fine mesh face. Very difficult prints for a budget machine like the Ender 3, but this glass surface makes it possible.

Haven't tried the glass yet, just received it and from the start the box looked damaged and when I opened it I found broken glass . . Luckily one of the leaves survived, so I'll build and update it later when I test it. Just a note on the box itself, not only were there no fragile items on the box but just those 5mm thick foam sheets to keep it from breaking. Besides the minimal protection of the packaging, it seemed like the bed clips provided had no safe place for them, which to my knowledge…

I was really excited about these glass beds because I have a slight warping of my Ender 3 bed. I have 5 printers and ordered two packs of these glass beds because one of my printers has a glass bed from the hardware store. The excitement evaporated almost immediately, I installed the glass beds and attempted to level the bed. I thought these glass beds look nice and flat. You are not. There are multiple irregularities on the glass, ranging from central indentations to random indentations. The…