🚲 Black Rambo Bikes R150: Extra Large Cargo/Luggage Rear Bike Rack Review

Works on my Rad Rover Step-Thru. It's not perfect, but it can be done with a little fiddling. RadPower ran out so I tried this one. This worked for me.

Looks like a good luggage rack for Rambobikes but the seller is wrong saying it's too big. This is just a regular sized bike rack that won't fit a fat bike.

This item is good after a little tweaking. The extra bars fitted under the seat are too long. I have a Goplus e-bike and needed a shorter stem, so I used a tube bender to bring it down to 6" to 7" diameter. I will use it to support my backpack when I go hunting and it does a great job. Happy with this product.

Not used much yet, so I can't give a very good rating yet. I actually bought this for my RAD Rover. All I had to do was go to the hardware store and buy the right screws. Everything else is alright. Some snaps where it attaches to the seat. I had to add an extra screw between the reflector's attachment point and the brackets on the post. I think if I use 1 extra screw it will fit even better.

I can confirm that this will work on some mountain bikes except the Rhino brand. I use it on the upper tubes next to the rear dropouts and on the included rear v-brake bolts. The short bars included mounting holes for this particular GT mountain bike. It's a bit tight on the disc brake side, though, so I plan on using 1/8" rubber shims as shims, not only to give a little extra clearance, but also to provide a bit of cushioning (and prevent any potential chatter) . Decent product, it's light and

Based on the photos of this item I decided to take a chance and order it to see if it will fit on my Motobecane sleeper train. The mounting points ended up in the same places as my fat tire bike, but I wasn't sure it would work. The item has arrived and it appears to be a sturdy tubular aluminum frame. It comes with mounting hardware but the screws were 6mm. The soldering on my frame is typically M5 (e.g. for water bottles) so I had to find some 20mm M5 stainless steel screws for the bottom…