Rannb Mandrel Cornhole Plywood Cutting Review

According to my experience, this product is a total waste of money and time. The quality of the plywood material is very poor and the holes are not aligned properly, causing a lot of frustration and eventually leading to an unusable end product. The only positive aspect is that it falls under the category of Industrial and Scientific, but even that doesn't make up for the poor performance. Avoid this product if you want an accurate and smooth cut for your project.

Well packaged but the problem is the paint they used on everything including the bit did not allow the cartridge to be screwed onto the cutter head. I had to turn and turn until the paint wore off. I'd say go to the port but that's a few bucks cheaper for the same issues.

That's nonsense! First, let me say that I rarely write negative reviews. This hole saw was so bad I just had to warn others. This thing breaks in the first few seconds of use. The pins that attach the hole saw to the chuck broke almost immediately, rendering it unusable. I tried to put the pins back in, but because they snapped it held, so it started to bend. I couldn't finish my project because of this piece of junk. I am returning this item.