🖨️ Discover the Innovative ELEGOO ANYCUBIC Photon Printer: Unleash Your Creativity! Review

Perfect replacement for my Anycubic Photon. These replacement films have a protective cover/sticker on both sides. When I first installed it, I only took one off and the other grabbed the bed. My mistake however, after replacing it again and realizing it had 2 layers of protection, it worked great and is a lot cheaper than the replacement sheet they sell on the Anycubics website.

No more protruding parts and easy to replace if you follow a good guide on youtube on how to replace them. Please Note: Please ensure you have your Gatorade bottle cap and setup app prior to installation. Oh, and be in a quiet room when setting it up or the app won't help. And it's not a drum, so tapping gently but firmly with something like an eraser on the end of a pencil works best. Other people recommend something different, but don't use anything that might puncture the film. Happy 3D…

There is a short video on how to replace them for my printer (AnyCubic Photon). There are a lot of screws, but in the end everything turned out to be very simple and took no more than 5 minutes. Clean everything first and make sure you have a soda or water bottle cap. When reinstalling, place it under the plastic to create tension on the first set of screws. Remove it when you reconnect it to the VAT and it holds on nicely. Use a razor or X-Acto knife around the inside edge to lightly trim away