🔧 CARBIDE Aluminum Router Bits Set Review

It took me a while to write this review because I wanted to make sure it wasn't a user problem. You are boring. Put simply. I have a better edge and fewer chips and gaps with better cutters. However, for an amateur like me, they work if you slow down. I will be buying a full set of the best beats soon but for now these will work.

Bought a set of these about 4 years ago and still use them although I've got a 24 bit set right now I bought this simply because the price is great and I'm very happy with the first set, I can't go wrong with these bits (of course, as with all cutters, the bearings tend to wear out after repeated use, I think I used mine a year ago , after a bearing has failed, so proceed with this plan and order a replacement bearing set, keep your finger on the pulse.

As a new user and owner of cutters I found these bits really good. I have nothing to compare them to, but they served me well when I needed 2x6 mahogany for a project. The only negative I can think of is that the yellow coating wears off after about 30 minutes (accumulated over several 5 minute sessions of continuous use) and the coating was quite thick rather than thin. The bits felt sharp right away, and even the one bit I've used so far has a worn yellow finish that still has very sharp…