🔌 RV Designer S247 Rocker Switch - 10 Amp, Illuminated On/Off, SPST, Black/Red, DC Electrical Review

Exactly matches the factory replacement on my 2015 Flagstaff V-Lite water pump switch. Bought some spares just in case.

Almost the same. The fit was perfect! The only problem and I was under the impression that the light only worked when the pump was on. The light stays on when off or on. Is it possible to turn on the light only when the pump is on?

Exact replacement for the blue light that was in the trailer but was too bright and the blue light disturbed sleep. So I switched to this one in red. Same function, same manufacturer (Sigma Switches Elkhart) and most importantly, the backlight is always on so you can find it at night.

I installed them in my 2012 Jayco Greyhawk Class C RV. The existing water heater switches did not light up and my wife and I wanted a more visual solution to knowing if the switches were on. They mount directly into cutouts for other switches and when connected quickly they light up and work great.

The switch works great but be careful if the light stays on in both switch positions you will have to swap two of the three connections. On my Jaco, these are the two lower connections. You need to connect the red + connector to the middle connector of the switch and the other (I have the blue connector) to the bottom connector of the switch. Above white - the connection remains the same. If you connect the switch to the wire terminals the same way you did the old one, you'll get…

If you want it to only light up when it's on, here's how to connect it. I used to replace a pump switch and wanted it to only light up as a reminder when the pump is on. The 12 volt power cord connects to the center pole marked +. The cable to the item you want to power connects to the paddle marked -. You'll need to run a separate ground wire to an unmarked shovel if you want the light to work. I was replacing a two wire switch, so I had to run a different wire for that purpose. It took a bit…